Tristate Machinery Dismantlers Forum > ILLINOIS
> Machine Parts
> Used
> Boschert 10 gauge hydraulic power notcher
Boschert 10 gauge hydraulic power notcher
YOU ARE VIEWING A VERY NICE BOSCHERT 10 GAUGE HYDRAULIC POWER NOTCHER. THIS UNIT IS IN EXCELLENT CONDITION
REPLACEMENT COST NEW IS OVER $10,000!!
5/32" - 10ga Hydraulic Power Notcher
5/32" mild steel, 10ga stainless steel
* 10 ga. stainless steel capacity
* Front to back cutting to hold material against stop
* Milled bed surface for no float or stick operation
* 35" wide by 25" deep table with milled surface so material does not float or stick
* Hi-Carbon, Hi-Chrome blades that overlap on the cutting edge to eliminate blade chipping
* Internal stop for shearing
* Two heavy-duty adjustable stops with 12" horizontal bars
* One engraved brass scale and T-slot parallel to each blade
* Moveable electric foot pedal
* 50 strokes per minute (adjustable)
* Jog, single or continuous mode
The patented Boschert TRI-GIDE system gives all Boschert notching machines the greatest accuracy and durability of any notcher made today.
TRI is for the three large guiding cylinders. Two cylinders are in the top of the machine, close to the blades, the third is in the base and fully integrated with the hydraulic piston.
GIDE is for the precise vertical travel of the ram. Torque from cutting heavy material is distributed evenly to all three cylinders.
* Blade clearance adjustment for different material thicknesses
* Frequent blade sharpening due to sloppy guiding
* Uneven wear, and replacement problems with
traditional guiding systems
Exclusive TRI-GIDE Benefits -
* Long blade life due to precise, rigid ram guiding
* Burr-free cuts on all gauges (within capacity)
* Off-center loading 1" x 6" notch is no problem
TRI-GIDE is just part of the overall quality and ingenuity that goes into every Boschert Notcher. Other features include:
* Front-to-Back cutting - holds material against stops
* Milled table surface keeps material from sticking
* Hi-Carbon Hi-chrome Blades overlap on the cutting tip to eliminate blade chipping
* Thousands of machines installed in North America
* Parts for all machines ever built are available
