Tristate Machinery Dismantlers Forum > ILLINOIS
> Motors and tools
> New 25 hp rotary phase converter panel
New 25 hp rotary phase converter panel
New 25 HP Rotary Phase Converter Panel
Build your own Rotary Converter
ALL YOU NEED IS OUR PANEL AND A 30 HP 3 PHASE 240 VOLT 1700-1800 RPM MOTOR!!!!
ALL NEW!!!....MADE IN USA!!!.... NOT AN IMPORT!!!..
- On/Off Switch (Other manufactures lack this feature. Without a switch a $250.oo Mag starter would be required to start the converter.)
- Auto Starting Unit. (There is no push button system used to start this converter.)
- 220-240 volt single phase power in, 220-240 volt 3 phase power out.
- Ready to run out of the box. (This is not a kit. Fully assembled.)
- Easy Installation. (2 boxes located on the top of the Phase Converter, One single phase power in the other 3 phase power out,
allowing an easy connection to your 3 phase equipment. Also side box for the idler motor hook up.)
- High amperage high quality contactors
- Super heavy duty oil run and start capacitors.
- All components and wiring soldered (always a good connection)
- Larger wiring for high amp loads (no burnt wiring)
- High temperature wire terminals (to eliminate short outs)
- E-Mail: ****@andersonconverters.com
- High quality electrical components
- Tech support with over 32 years experience in electrical including all types of machinery and equipment
WE MAKE ALL SIZES STATIC AND ROTARY CONVERTERS
Click here to check out our other Phase Converters!
