Tristate Machinery Dismantlers Forum > INDIANA
> Industrial Machines
> Ultra precision 10PPM 16.000MHZ mil-spec oscillator
Ultra precision 10PPM 16.000MHZ mil-spec oscillator
One piece Linear Components: 16.000MHz Ultra Precision Millitary Specification model number: M55310/16B31A 16.000M 10PPm Mil-Spec Hybrid Crystal Oscillator
Part number : Linear Components : A103 / M55310 MIL-SPEC HYBRID CRYSTAL OSCILLATORS (ORION SERIES)
MIL-SPEC HYBRID CRYSTAL OSCILLATOR
A Crystal oscillator is a frequency controlled timing device that consist of a quartz crystal blank and oscillator circuitry, which provides an output waveform at a specific referenced frequency. MIL-SPEC hybrid crystal oscillators are compliant to govermental agencies standards and regulations.
To view the Data Sheet access this link: http:// /files/A103.pdf
PERFORMANCE SPECIFICATION SHEET
OSCILLATOR, CRYSTAL CONTROLLED, TYPE 1 (CRYSTAL OSCILLATOR (XO)), 0.1 Hz THROUGH 80 MHz, HERMETIC SEAL, SQUARE WAVE, TTL
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
The requirements for acquiring the product described herein shall consist of this specification and MIL-PRF-55310.
MIL-PRF-55310/16H 2 REQUIREMENTS:
Interface and physical dimensions: See figure 1.
Seal: Hermetic in accordance with MIL-PRF-55310, maximum leakage rate 5 x 10-8 atm cc/s.
* Oscillator: Class 2 or any class 1 or class 3 oscillator meeting all class 2 requirements and verification tests specified herein and in MIL-PRF-55310.
Calibration: Manufacturer calibrated.
Screening: In accordance with MIL-PRF-55310, product level B or S, as applicable.
Oscillator load: Standard TTL loads (see table I).
Output waveform: Symmetrical square wave.
Supply voltage: 5.0 V dc 10 percent.
Input current: At designated supply voltage (see table I).
Output frequency: Frequency as designated at time of acquisition (see table I).
Output voltage: At designated TTL load (see table I).
Rise and fall times: See table I.
Initial frequency-temperature accuracy (one-half temperature cycle): Verification applicable. 1/
Frequency-temperature tolerance (one-half temperature cycle, referenced to frequency measured at +23 C 1 C, immediately prior to starting of the test): See table I. Measurements taken at ten equally spaced increments over the specified operating temperature range. 1/
1/ For the purpose of transitioning this device to MIL-PRF-55310, Frequency stability versus temperature has been renamed Frequency-temperature
tolerance . The verification requirements of initial frequency-temperature accuracy (one-half temperature cycle) shall apply except that frequency measurements shall be referenced to the frequency measured at +23 C 1 C (fref) instead of to the nominal frequency (fnom).
Custodians: Preparing activity:
Army - AR, MI, SM (Project 5955-0747)
Operating temperature: 5 degrees celsius ~ 100 degrees celsius
