Tristate Machinery Dismantlers Forum > MICHIGAN
> Electrical Components
> Used
> Microprocessor timer counter eagle signal CX300
Microprocessor timer counter eagle signal CX300
Comes with installation instructions and some install hardware.
The CX300 is a microprocessor based timer / counter housed in a standard 15 terminal CYCL-FLEX plug-in case which allows easy removal for programming changes and replacement. Time or count operation, time range, and the type of start input switch operation are programmed with 7 miniature rocker switches located inside the unit housing.
The front panel of the CX300 is a sealed membrane keypad which provides excellent protection for most industrial environments. The time or count setpoint is entered using the increment and decrement keys for each digit position. The SET and ENT keys provide access to the setpoint, as well as to the front panel programmable software functions. These programmable functions control the pulse output length, setpoint to zero or zero to setpoint cycle progress indication, and count input scale factor. The software programming functions are indicated by prompts to help the user program these functions without the need for written instructions.
* Keypad lock function allows viewing of setpoint, but does not allow unauthorized changes
* 4 1/2 digit (19999) liquid crystal display - .5 inch high digits
* Annunciators (right of the display) flash to indicate timing or counting
* Two form C instantaneous contacts and two form C programmed contacts
* Five time ranges from 19.999 sec. to 199 hr.: 59 min.
* Three count rate input rate speeds are programmable with a max. count display of 19999 - can be extended via count input scale factor
* 24, 120, or 240 VAC operations
* Count input available for 120 volt AC or low voltage AC/DC operations
* When programmed as timer, count input circuit serves as time inhibit (without resetting the unit)
