Tristate Machinery Dismantlers Forum   >   STATE OF IOWA   >   Electrical Components   >   10”X15” heidelberg windmill printing /die cutting press

10”X15” heidelberg windmill printing /die cutting press


10 X15 HEIDELBERG WINDMILL Printing/Die Cutting Press
Condition : Used, but still runs reliably.
This item was pulled straight off my own print shop press room floor. It is functional and the only reason I am moving it is because I have run out of space. It is currently set up to run as a die cutter. It can be used for scoring, perfing, die-cutting, printing, and more. The swing arm is a little worn out on both sides, so the sheets don't always hit in exactly the same spot, but other than that there is nothing wrong with this item.
* Maximum Sheet Size: 10.25" x 15"
* Minimum Sheet Size: 1.5" x 2.75"
* Inside Chase Measurement: 10.25" x 13.375"
* Gripper Margin: 0.5" (approx.)
* Maximum Speed: 5000 impressions per hour
* Minimum Caliper of Substrate: 0.002"
* Maximum Caliper of Substrate: 0.020"



10”X15” heidelberg windmill printing /die cutting press