Tristate Machinery Dismantlers Forum > STATE OF IOWA
> Industrial Machines
> The hobart 500534A airforce 250CI plasma cutter
The hobart 500534A airforce 250CI plasma cutter
* Designed to cut up to 1/4-inch mild steel; uses an electrical arc and compressed air to cut steel, aluminum, and other conductive metals
* Use it for a more precise cut, thinner kerf, and less slag to clean up with faster cuts than oxy fuel
* Includes 16.5-foot heavy duty work clamp, 7 -foot power cord with 115 VAC plug, extra replacement tips, and a convenient cable management strap
* 10-by-7-1/2-by-13-inches at 27-pounds; backed by Hobart limited warranty
The Airforce 250ci uses an electrical arc and compressed air to cut steel, Aluminum and other conductive metals. Designed to cut up to 1/4-inch Steel by using a standard household current. A built-in air compressor and lightweight inverter power supply make this Plasma Cutter the most convenient, totally portable cutting system available. The Air force 250ci excels at cutting sheet metal and 1/8 in mild steel. Weight of Machine is 27-pounds.
The new AirForce 250CI plasma cutter with built-in air compressor features a new lightweight design that is both lightweight and powerful. Built-in compressor for total portability and low system cost. Cuts mild steel up to 1/4in. thick using standard household current. New HP-25 torch is more comfortable, efficient and economical. U.S.A. Cutting Thickness (in.): Up to 1/4, depending on material, Volts: 115, Amps: 20, Duty Cycle: 35% @ 12 Amps, 110 Volts DC, Pilot Arc: Yes, Plasma Gas Flow/Pressure: Preset with built-in compressor, Clamp Cable Length (ft.): 16, Power Cord (ft.): 7, Cart: No, Dimensions L x W x H (in.): 7 1/2 x 13 x 10
