Tristate Machinery Dismantlers Forum > WISCONSIN
> Electrical Components
> Used
> Quick fist xl mount just about anything up to 15"
Quick fist xl mount just about anything up to 15"
QUICK FIST XL Mount Just About Anything up to 15"
Mount Tools and Equipment On Any Vehicle
The QUICK FIST XL clamps are not only our largest size, but they are also our strongest clamp. They provide a safe working load of 150lbs (68kilos), and a break-strength of 300lbs (176kilos) per clamp. Two clamp sets support up to 600lbs (273kilos).
QUICK FIST XL (Package of 2 sets of clamps) holds objects up to 15 (381mm) in diameter or about 30 (762mm) in a linear direction.
Each base of the clamp mounts with four #10 screws or bolts (not included).
QUICK FIST XL can be used to hold large bottles (acetylene, helium, propane), Jerry cans or other type of fuel tanks, tool boxes, floor jacks, small coolers and other equipment too large for our smaller clamps.
QUICK FIST clamps are made in the USA of heavy duty transportation grade rubber and are not affected by hot or cold climates or salt. The rubber is uv resistant
Will hold round objects up to15 (381mm) in diameter.
? Holds tools and equipment measuring up to 30 (762mm) in linear distance.
? Each clamp set supports a safe working load of 150lbs (68kilos), with a break-strength of 300lbs(176kilos).
? Each base of the clamp mounts with four #10 screws or bolts (not included)
XL Quick Fist Installation Instructions
1. The two pieces of the clamp must be mounted with each side facing as illustrated and with the arrows on each base facing each other. Use four #10 bolts or screws and appropriate size washers to fasten each base. Do not over tighten.
2. If you are mounting a cylinder, make sure the bottom is on a floor, deck or shelf. Alternatively, support it with a piece of angle iron or wood block (see illustration). This makes it easier to tighten the straps with two hands.
3. Mount the base so that the strap is parallel to the outside edge of whatever you are holding.
4. The ladder half of the clamp can be stretched up to about an inch by pulling on the strap (NOT the ladder steps or cross pieces) in several places along its length.
5. If you are holding a cylinder, tighten by putting the jaw half through the tightest ladder section and then pull the two halves in opposing directions. If your tightening a rectangular piece of equipment, you need to push the ladder half as far as possible while keeping the jaw section flat.
