Tristate Machinery Dismantlers Forum > ILLINOIS
> Electrical Components
> New
> With Warranty
> Rocker milling clamps sherline taig traditional
Rocker milling clamps sherline taig traditional
Set of 2 hold down clamps of a non-symmetrical, more traditional shape (see 2nd photo). Screws and washers are not included with this set. T-nuts are available separately if needed for $1.25 each (please check other items, or ask). More traditional shape gives higher auto adjustment capability without stacking blocks (0 to 1-1/8). This would be a great start, and then add stacking blocks later if you find you need the extra height, though 1-1/8" without the stacking blocks is nothing to sneeze at. These are extremely handy little clamps for holding work pieces down on a milling table, tooling plate or fixture. The slot allows for a certain amount of lateral reach necessary for use with tooling plates. The self adjusting height is a real time/frustration saver. Optional range extender stacking blocks are available (please check other items, or ask).
These are shaped slightly different than the symetrical clamps shown on the tooling plate in 1st photo and they don't include the stacking blocks. Again their compactness make them especially ideal for machines with limited table or tooling plate surface area.
