Tristate Machinery Dismantlers Forum > ILLINOIS
> Electrical Components
> Used
> With Warranty
> New us cooler 6'X8' id walk-in cooler top mount ref. -
New us cooler 6'X8' id walk-in cooler top mount ref. -
US Cooler 6'x8' ID Walk-in Cooler Top Mount Ref. - NEW
US Cooler Indoor Walk-in Cooler
1/2 HP -Top Mount - Indoor refrigeration system
6' X 8' X 7' 6" Nominal (5' 10 1/2" X 7' 10" X 7' 6" Actual)
This walk-in comes with a 1/2 HP top mount indoor refrigeration system. System comes with a condensing unit, evaporator unit, and associated parts installed on a walk in cooler plug. This unit is pre-charged and ready to be set in the top mount refrigeration hole on top of the walk in. It does require the installation of the evaporator condensate line, which needs to be run to a drain. This refrigeration system rates a 2 on a scale of 5 with 5 being the hardest most technical to install and 1 being the easiest. This refrigeration system must be installed by a licensed refrigeration technician. Our company can assist you with this requirement.
* This indoor walk-in requires a minimum of 4,522 BTUs.
Refrigeration system is designed to hold product at 35 degrees Fahrenheit with product entering at 55 degrees Fahrenheit.
REFRIGERATION - Top mounted refrigeration system, self contained, med temp, 1 phase, 1/2 HP, hermetic, 115 volt. Includes: Copeland condensing unit, evaporator, thermostatic expansion valve, high pressure control, sight glass, drier, solenoid valve, thermostat. maximum low 35 degrees. refrigerant - R22. Unit mounts on a 22 1/2" x 33" plug.(Refrigeration is based on an altitude of 5000 feet or less)
PANELS - Wall and ceiling panels are constructed with tongue and groove 1 1/4 LB expanded polystyrene insulation sandwiched between two sheets of 26-gauge stucco embossed galvalume steel. Each panel comes equipped with cam action locking devices and double barrel vinyl gasket to allow easy assembly of walk-in in the field.
