Tristate Machinery Dismantlers Forum > ILLINOIS
> Machine Parts
> New
> Ipm 01 transfer pump- less $ for graco gusmer glascraft
Ipm 01 transfer pump- less $ for graco gusmer glascraft
IPM 01 Transfer Pump- Less $ for Graco Gusmer glascraft
but it can stop you dead in your tracks and cost you lots of $$!
Most distributors are sending units out with OP 232C Gusmer pumps:
1) COST! $$$ then there is the cost!
This pump that I'm offering is an IPM 01 1:1
It has no plastic washers to break! The air motor has o rings that will last much longer!
The output is well above any production to most spray units! See chart below for exact specs.
This pump retails for over $520.00 Ouch!!!!
I'm offering to you for a low cost of $499.00!!!!!
I have been in the coatings and foam industry for 12+ years and know what works and what doesn't!
I am NOT a sales man from some supplier but one of you!
Hey guys I am concerned about the pricing at graco and this is one of the ways I'm improving my bottom line, not Graco's or some other suppliers pockets!!
CALL TODAY! (***)-880-7787 its my cell phone... or my store professorfoam.com
Graco has just introduced the T1, its basically the same as the IPM-02 but its cost is $1055.00! Graco's way of saying thanks! Thanks for your hard earned $$!
