Tristate Machinery Dismantlers Forum > INDIANA
> Industrial Machines
> Used
> With Warranty
> Tube notcher by JD2 for notching serious tubing
Tube notcher by JD2 for notching serious tubing
The Official TN100 Tube Notcher made by JD2.
Forget the copy cats... go with the best. When you have a frame to build, you don't have time for poor quality. You NEED a notcher that will get the job done fast and right!
Notches 3/4" through 2" O.D. tubing at angles up to 50 degrees.
Easy To Use- May be mounted in a drill press or simply clamped in a vise and used with a 1/2" hand drill. The 1/2" hand drill setup is by far the best in our opinion. In this way the tube notcher can be laid horizontal and when notching 45 degree angles the floor will not interfere with the tubing being notched. Also, since the hand drill is fed in horizontally, the drill's weight doesn't try to force the hole saw in too fast. Heavy duty clamping system to keep your tube solid in place, heavy duty steel shaft with needle bearings for a solid cut.
Note: Uses commonly available bimetal hole saws. NOT INCLUDED
