Tristate Machinery Dismantlers Forum > MICHIGAN
> Motors and tools
> New
> With Warranty
> Electric forklift battery pack changer electromagnet
Electric forklift battery pack changer electromagnet
Raymond Corp Battery Carrier Electric Pallet Jack Model 101T-F40L NO BATTERIES INCLUDED
* Model Number # 101T-F40L
* for removal of large battery packs from forklifts
* Manufactured By Raymond Corporation
* Carry Compartment Dimensions: 24 by 42
* ~1628 lbs, 30 by 88 by 59 inches raw
This is a Raymond Electric Pallet Jack with an electric forklift battery changer attachment. It is designed for changing out big battery packs from regular electric forklifts. It uses a linear drive and an electromagnet to pull the battery packs out.
No Specific Information About This Model Can Be Located Through Raymond Corp However Their Website Can Be Located Here:
An electromagnet motors out to the front and attaches to a battery case in an electric forklift.
The magnet motors back into the pallet jack attachment to extract the battery from the forklift.
This image shows a chain and hook being held by the electromagnet.
Note this image that shows the hand control pendant for the battery changer part. It is on a coil cord and can be taken to where ever it is most convenient for the user.
Raymond Corp Model # 101T-F40L, Serial Number 101-95-04843, 24 Volts, Truck Weight With Maximum Battery 1520 lbs, Without Battery 810 lbs, Battery Weight Maximum 710 lbs, Battery Weight Minimum 200 lbs, Battery Rate 600 Amp / 6 Hrs, Maximum Capacity 4000 lbs.
This image shows the basic controls that this unit operates on. Top button is used to lift the machine, the second button is used to lower the machine, the third button is a small horn. This machine is equipped with two very special safety features. The handle is spring loaded, which means that you must pull it down to begin using this machine, if for any reason you let go of the handles while using this machine it stops immediately and enables the braking mechanism to stop the machine from moving until you resume normal operation. The second safety feature is the large red button at the end of the handle, If this button is depressed during use it will also stop the machine from moving until what ever caused the button to depress is removed, This is used to prevent the machine from running into the operator and causing injury.
The hour meter shows 538 hours. The machine does not look like it has been run this much.
This might be just what you need for your order picking and battery removal application.
