Tristate Machinery Dismantlers Forum   >   MICHIGAN   >   Motors and tools   >   Used   >   With Warranty   >   Smt to dip adaptor boards, for 25 ic's, msop tsop, smd

Smt to dip adaptor boards, for 25 ic's, msop tsop, smd


This PCB is about to be updated to a new format,
Accurate information about the new PCB will only be available after April 30 2010
SMT -to- 0.100" DIP chip carrier
Board contains 25 tiled individual chip carriers. PCB has V-scores, so individual tiles can be broken off by hand.
Takes standard 0.100 header pins for legs.
Header pins not included, but available on request.(see below)
You can also purchase individual tiles, or lower pin-count tiles, available in my listings (search for "SMT")
Example of a finished adaptor. Header pins not included
contains 5 tiles of each style below
Below: the right way to solder pins to a carrier. You insert the pins in a solderless breadboard to keep them firm and parallel. Then seat the carrier PCB on top of them and solder. This way, you can even get away with combining smaller header fragments ( a 3 pin and a 4 pin to make 7 inline), and recycle what you already have.
Click here for bitmap scan of the PCB
Style 7 and 8 are for 0.05" pitch.
Style 7 is a COMPACT PINOUT, in which the taces take the shortest path to the nearest pin. Minimizes lead length and overall size, but resulting pinout is not sequential. Keep this in mind when using.
Takes IC's with 8-16 pins , all widths made in this pin range.
Style 8 ia a sequential puinout. Takes IC's with 8-20 pins , all widths made in this pin range.
Style 9 and 10 are for 0.025" quarter pitch. Will accomodate 0.625mm and Metric 0.65mm pitch.
Style 9 is a compact pinout for IC's of 8-20 pins.
Style 10 is a sequential pinout for IC's of 8-28 pins.
Takes all case widths made in this pin range.
Style 11 is a SOIC-8 carrier with single-in-line pinout, suitable for breadboarding.
Holes are large enough to accomodate standard low-cost square header pins. However machined pins are preferred, and should be used if possible.
Most of the time I have these pins available. If you do not see them in my listings, please email.