Tristate Machinery Dismantlers Forum > STATE OF IOWA
> Motors and tools
> New
> Without Warranty
> 4 axis nema 34 stepper motor 1317OZ cnc router or mill
4 axis nema 34 stepper motor 1317OZ cnc router or mill
4 PCS Nema 34 Stepper Motor with 1317oz-in holding torque,
4 PCS Stepper Driver with 8.2A replacing MD882,
2 PCS Power Supplies for 200W,24VDC,
1PC Breakout Board for free offering
Holding torque: 9.3N.m 1317oz-in
Introduction,Features and Applications
The SD-2H086MB is an economical microstepping driver based on patented technology of Wantai Motor .It is suitable for driving 2-phase 4-phase hybrid stepping motors .By using the advanced bipolar constant-current shopping technique ,it can output more speed and torque from the same motor,compared with traditional drivers ,such as L/R drivers .Its 3-state current control technology allows coil currents to be well controlled and with relatively small current ripple,therefore less motor heating is achieved.
Low cost and good high-speed torque
Suitable for-2-phase and 4-phase motors
Dip switch current setting 8different values
Optically isolated input signals
Automatic idle-current reductiOn
Small size (107*97*48),Weight:1KG
90 132VAC/180-264VAC 47 63Hz;255 370VDC
105-145% TYPE OUTPUT CUTOUT AC Restart
10 500Hz,2G 10min,/11cycle,60min,each axes
I/P-O/P:1.5KvACI/P-FG:1.5KvACI/P-FG:0.5KvAC
I/P-O/P,I/P-FG,I/P-FG:500VDC/100M
1.All parameters NOT specially mentioned are measured at 230VAC input ,rated load and 25 of ambient temperature.
2.Tolerance:includes set up tolerance,line regulation and load regulation
3.Ripple&noise are measured at 20MHZ of bandwidth by using a 12 twisted pair-wire terminated with a 0.1uf&47uf parallel capacitor.
4.Line regulation:min&max voltage of the rated load.
5.Load regulation:load from 0 to 100%
* Built in DB25 male connector.
* DB25 Output Pin:P1,P2,P3,P4,P5,P6,P7,P8,P9,P14,P16,P17.
* DB25 Input Pin: P10,P11,P12,P13,P15.
* Built in C-class Optical-coupler.
* High quality with Surface-mount Tech.
