Tristate Machinery Dismantlers Forum > WISCONSIN
> Electrical Components
> New
> Without Warranty
> Wadsworth fuse holder 8055 / 8056 100 amp ______I12
Wadsworth fuse holder 8055 / 8056 100 amp ______I12
Wadsworth Fuse Holder #8055 / #8056
Top * 8056 WADSWORTH 100 AMP PULL OUT 3 7/8" X 7" INCHES
* Has Wadsworth number 8056 on the underside of the top.
Base * 8055 WADSWORTH 100 AMP PULL OUT RECEIVER
* Has the Wadsworth number 8055 on the underside of the base.
* The overall length is 9 3/8" and the overall width is 4 1/4".
* The inside length is 7" x 3 7/8".
These are USED but in good condition, it does have a chip in the base at the top corner. It is is "V"-shaped and 3/8" wide at top and goes down 1/2". When the top is slid in to place the edge of the top covers the chip. It does not effect the performance of the fuse holder.
