Tristate Machinery Dismantlers Forum > WISCONSIN
> Electrical Components
> Used
> With Warranty
> Infusion zoll power infuser fluid resuscitation pump
Infusion zoll power infuser fluid resuscitation pump
INFUSION DYNAMICS / ZOLL POWER INFUSER FLUID RESUSCITATION PUMP
*This Pump Has Been Thoroughly Inspected AND Tested By Hamel Medical in Yukon, OK And Is Biomedically Certified Until March 2011.
It Is Ready To Go To Work Today!!*
This Offer Includes The Following:
* (1) ZOLL POWER INFUSER PUMP: Model# M100B-3A (Part# 0040-0013)
* (40) SURPLUS CRYSTALLOID & COLLOID PUMP CARTRIDGE & IV SETS; Part# 0040-0050 (Please see below regarding cartridge details)
Max Flow Rate: 6 Liters Per Hr
Min Flow Rate: 0.2 Liters Per Hr
BOLUS Setting: 250 ml In 2.5 Minutes
Flow Profile (1-6, BOL): Pulsatile
Flow Profile (0.2) Intermittent (on 4 Sec @ 1 lph, off 16 sec)
Free Flow: Yes, If Fluid Source Above Patient
Retrograde Flow: Prevented By Valves
The Power Infuser is the first portable electronic infusion pump designed specifically for the management of IV fluid and blood. Small, durable and easy to use, it is your assistant at the scene of an accident, during transport, or in the hospital.
The Photos In This Offer Are A REPRESENTATIVE Item, Of All Of The Pumps And Cartridges In Stock
A unique cartridge with air elimination membranes that when used with the Power Infuser is intended to deliver crystalloid and colloid resuscitative fluids. It is not intended to support the infusion of blood or blood products.
*CRYSTALLOID & COLLOID PUMP CARTRIDGE & IV SETS DETAILS:
These Crystalloid & Colloid Pump Cartridges Are For The Power Infuser ONLY.
-Sterile, Single-Use Only and Latex-Free-
(40) INFUSION DYNAMICS / POWER INFUSER
CRYSTALLOID & COLLOID PUMP CARTRIDGE & IV SET
For Rapid Intravenous Infusion Using The Infusion Dynamics Power Infuser.
*Do Not Use With Blood Or Blood Products
(40) Pump Cartridge W/ Female Luer Inlet Connector, Air Elimination Membranes & Blue Male Luer Outlet Connector.
(40) Pump-To-Patient IV Set W/ Blue Female Luer Inlet Connector, 'Y' Injection Site, Pinch Clamp & Male Luer Needle Adapter. Length: 18 Inches (45 cm). Total Priming Volume: 11 ml.
INCLUDES: Air Elimination Membrane (Crystalloid/Colloid Cartridge Only)
Compatible Fluids Crystalloid or Colloid IV Fluids
Incompatible Fluids Medications, Blood Products & Non- Ionic Fluids
Priming Volume - Cartridge 7cc
Priming Vol - Cartridge & 18" Segment 10cc
Outlet Connector Male Locking Luer
Air Elimination Method Hydraphillic Filter / Hydrophobic Vent
This Crystalloid & Colloid Pump Cartridge Is For The Power Infuser ONLY.
*PLEASE NOTE THAT THE PRODUCTION DATE IS
NOVEMBER 11, 2005 AND THERE IS NOT AN EXPIRATION DATE LISTED*
*THE CARTRIDGES DO NOT HAVE ANY WARRANTY
