Tristate Machinery Dismantlers Forum > WISCONSIN
> Electrical Components
> Used
> Without Warranty
> Rainin motorized microliter pipette 250
Rainin motorized microliter pipette 250
Rainin Motorized Microliter Pipette 250
EDP1 Electronic Pipettes use a motorized linear actuator to move the piston. The
linear actuator, controlled by a miniature on board computer, moves the piston
the correct distance,at the correct speed, every time. Piston strokes are
consistent and reproducible. Each complete EDP1 pipette includes a control
module, battery pack, a wall power supply, and aliquid end for the volume
range ordered. The control module is the same for all volume ranges; an encoder
plug informs the control module which liquid end is attached. For volumes up to
2000 ,interchangeable liquid ends with encoders can be purchased
separately. A stainless steel piston is moved by an electronic linear actuator.
The piston displaces a column of air which picks up or dispenses liquid through
a disposable polypropylene tip. This tip is the only part of the instrument that
touches the liquid. A mechanical tip ejector allows tips on all volume pipettes
to be ejected easily without hand contact, avoiding sample carryover and
contamination. You enter mode, volume, and speed settings into the EDP1 via a
keyboard. Operational status and settings are shown on an easy-to-read display.
Audible tones signal completion of piston strokes and error conditions. Pickup
and dispense are performed by pressing the trigger. Power can be supplied to
the EDP1 pipette in either of two ways: with a cord attached to a wall power
supply, or with a rechargeable Battery Pack for maximum convenience and freedom
of movement. With a fully-charged Battery Pack installed, the EDP1 will operate
for more than 1000 full-stroke cycles before recharging is
needed.Included you will get the rapid charger/pipette stand. charger/pipette stand.
