Tristate Machinery Dismantlers Forum > WISCONSIN
> Industrial Machines
> Used
> Without Warranty
> Pelton & crane autoclave and sterilizer guaranteed
Pelton & crane autoclave and sterilizer guaranteed
This sterilizer is designed for decades of headache free use
**Includes FREE autoclave tape**
***3 sterilization trays INCLUDED***
There is nothing built as good as a Pelton and Crane. Once you own one of these you'll never need another sterilizer unless you get busier.
The unit has been refurbished by a professional and is certified to work perfectly and easily from the moment it arrives. Just add water and electricity!
It can be used for all applications of sterilization including:
The unit includes the manufacturers operation instructions (OCM) and aluminum instruction card stored under the unit for convenient access.
OCM / OCR Operation Instruction (brief)
1. Place unit on a leveled surface. This will allow the chamber to fill with the right amount of water.
2. Fill reservoir 2 inches from top with distilled water.
3. Plug sterilizer into grounded outlet.
4. Put instruments on tray and into chamber.
5. While door open, turn bottom switch to 'fill' position, and leave at that position for about 50 seconds, until water reaches the front rim of the chamber. Please be sure timer is set on zero. *Note: Unit will not fill if timer is not on the off position*.
7. Make sure the middle knob is turned all the way clockwise. This will ensure 270f.
By turning the middle knob counterclockwise...you will be reducing the temperature.
8. Turn timer to appropriate time. This is only a timer and is not incorporated into the actual sterilization operation of the unit. I would recommend use of a secondary timer. The timer 'Ding' is hard to hear.
9. Turn the bottom switch to 'sterilize' position.
10. Both red & orange light will come on.
11. At end of cycle, rotate lower knob to vent.
12. When pressure gauge shows 'zero', you may open the door.
13. If you want the instruments to be dryer than they are...leave the door slightly open, and turn the bottom switch to vent position and set the timer to 10-15 minutes.
Call (***)-304-3216 with any questions
